Adjustments menu
m
Z
0)
E
YN
I
Q
Contrast : Adjust the screen contrast to match the brightness level in the room.
Pressing the [2] key toggles between brightness and contrast.
Direct operation
Even if the menu screen does not appear, the contrast can be adjusted by pressing
the [4 or B key. If the [4 and BP keys are pressed at the same time, the
|
maximum level (100) will be set.
xt
Brightness : Adjust the brightness to match the brightness level in the room so that the level
will be easy to see.
Pressing the [2] key toggles between contrast and brightness.
Note: If the Æ and $>) keys are pressed at the same time on the Brightness
adjustment screen, the standard leve! (50) will be set.
Size & Pos. : Press the [2] key to select the zoom / horizontal position / horizontal! size / vertical
position / vertical size adjustments.
>
Press the [1] key to save the adjustment.
ZOOM : Both the horizontal and vertical size of the image can be adjusted at the same
time; however, the aspect ratio cannot be changed.
Press the E$ key to make the image smaller, the ®) key to make it larger.
H. Position : The horizontal position of the image can be adjusted.
Press the [4 key to move it to the left, the à] key to move it to the right.
[=]
H. Size : The horizontal size of the image can be adjusted.
Press the [4 key to make the image smaller, the ®] key to make it larger.
Note: Setting the image in the center of the screen to start will make the
adjustment easier.
V. Position : The vertical position of the image can be adjusted.
f
Press the Ed key to make it downward, the ®] key to move it upward.
[1]
V. Size : The vertical size of the image can be adjusted.
Press the i key to make the image smaller, the $] key to make it larger.
Note: Setting the image in the center of the screen to start will make the
adjustment easier.
VA
Geom etry : Press the [2] key to select the vertical pincushion / side pincushion balance /
trapezoid / parallelogram / Geometry 2 adjustments.
Press the [1] key to save the adjustment.
IT
V. Pincushion
: The image can be corrected for barrel distortion.
Press the f@ key to decrease the Pin / Barrel distortion of the image,
l
the > key to increase it.
( T Side Pin. Bal. : itis possible to adjust the side pincushion balance to the left and right.
Press the 4 key to expand to the left of the image, the ® key to
|
expand it to the right.
LA
Trapezoid : The image can be corrected for trapezoidal distortion.
Press the Æ key to make the top edge narrower, the be] key to make the
bottom edge narrower.
L/
Parallelogram : The image can be corrected for parallelogram distortion.
Press the [4 key to collapse the parallelogram to the left, the P) key
to collapse it to the right.
» b Geometry 2 : Press the El key to change the sub OSD screen.
Press the [2] key to select the Top Corner / Bottom Corner / S-Curve 1 /
S-Curve 2 adjustments.
LT Top Corner : The image can be corrected for vertical pincushion distortion in the
top corner.
Fl
Bottom Corner : The image can be corrected for vertical pincushion distortion in
the bottom corner.
S1
S-Curve 1 : The image can be corrected for vertical pincushion distortion in the
S-Curve 1.
O e g
S2
S-Curve 2 : The image can be corrected for vertical pincushion distortion in the
S-Curve 2.
a
paN O
10