Metabo W 21-230 Instrucciones De Manejo página 12

02 ENG_9790_0205
ENGLISH
8
Locate the inner flange (8) on the spindle,
ensuring that the flange cannot turn on the
spindle. Position the cup-grinding wheel so that it
rests evenly on the inner flange.
Screw the clamping nut (10) or the Quick
clamping nut (9) onto the spindle. Lock the spindle
in position. Secure the cup-grinding wheel with the
clamping nut (10) or the Quick clamping nut (9).
Use the offset pin spanner (m) if the clamping nut
(10) is being used.
Set the cup-grinding wheel/wheel guard projection
as required (approx. 0.5 - 1 cm/0.2" - 0.4").
Slacken off the two wing screws and adjust the
wheel guard evenly upwards or down. Retighten
wing screws.
12.4 Wheel guard with cutting and chasing
guide for processing stone
To reduce dust: only cut stone slab to 2/3 of its
thickness, then break it.
13 Repairs
Repairs to power tools must be carried
out by a qualified electrician only.
Any Metabo power tools in need of repair can be
sent to one of the addresses listed on the second-
last page.
Please send the tool for repair with a brief
description of the fault identified.
12
18.12.2007 13:31 Uhr Seite 12
14 Environmental Protection
Metabo packaging is 100% suitable for recycling.
Power tools and accessories at the end of their
service life still contain large amounts of valuable
raw materials and plastics which can likewise be
fed back into a recycling process.
As the dust generated during grinding/cutting may
contain harmful materials, do not dispose of it
along with domestic waste but ensure it is taken to
a collection point for special waste for proper
disposal.
These Operating Instructions are printed on paper
produced in a chlorine-free bleaching process.
15 Technical Specifications
Notes on the details on page 2.
We reserve the right to undertake modifications to
reflect technical advances.
D = maximum grinding disc diameter
max
n = no-load speed
M = spindle thread
P = rated input
1
P = output power
2
I = current at 120 V
120V
a = typically rated acceleration in the
hw
hand-arm area
Typical A-rated acoustic level:
L = acoustic pressure level
pA
L = acoustic power level
WA
During operation, the acoustic level may
exceed 85 dB(A).
Wear ear protectors!
m = weight
Measured values established according to
EN 50144.
The stated technical specifications are subject to
tolerances (as specified in the respective current
standards).