Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
1. If possible avoid placing the appliance near cookers, radiators or in direct sunlight
as this will cause the compressor to run for long periods. If installed next to a source
of heat or refrigerator, maintain the following minimum side clearances:
From Cookers
4" (100 mm)
From Radiators
12" (300 mm)
From Fridges
4" (100 mm)
2. Make sure that sufficient room is provided around the appliance to ensure free air
circulation. Ideally, A space of no less than 10cm must be left around the freezer, and
ensure you allow gaps as shown in the below diagram.
3. The appliance should be located on a smooth surface.
4. It is forbidden to use the refrigerator outdoors.
5. Protection from moisture. Do not locate the freezer in moist space to avoid the
metal parts rusty. And do not spray water to the freezer, otherwise it will weaken the
insulation and causes current leakage.
6. Refer to "Cleaning and Care" section to prepare your appliance for use.
7. If the freezer is installed in unheated areas, garages etc., in cold weather
condensation may form on the outer surfaces. This is quite normal and is not a fault.
Remove the condensation by wiping with a dry cloth.
children to play with the appliance or tamper with the controls. Our company declines
to accept any liability should the instructions not be followed.
STARTING
Final Check
Before you starting to use the freezer, please check that:
1. The interior is dry and air can circulate freely at the rear.
2. Clean the interior as recommended under "CLEANING AND CARE".
3. Insert the plug into the wall socket and switch on the electricity supply， then the
Red light is on. Avoid accidental disconnection by taping over the switch. Green light
will glow and the compressor will start running.
English-7
Publicidad
