Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
when cleaning plastic parts . Most plastics are susceptible to damage from various
types of commercial solvents . Use clean clothes to remove dirt, dust, oil, grease, etc .
SHARPENING THE CUTTING BLADE
1 . Start and stop your hedge trimmer
until the cutter blade and the guard are
slightly offset, as shown in Fig . 9 . This
will allow clearance for the file between
cutter teeth and guard teeth .
2 . Remove the battery pack from you
hedge trimmer .
3 . Clamp the blade assembly in a vise
and file the exposed cutting surface
of each blade tooth . Remove as little
material as possible . Be sure to retain
the original angle of each tooth when filing .
4 . Remove the hedge trimmer from the vise; restart it and stop it to expose the
unsharpened edges of the blade teeth .
5 . Remove the battery pack and repeat the sharpening procedure above .
NOTE:
Do not operate your hedge trimmer with dull or damaged cutting blades .
This may cause overload and will give unsatisfactory cutting results .
56V LITHIUM-ION CORDLESS HEDGE TRIMMER — HT2400/HT2400-FC
Never use water for cleaning your trimmer . Avoid using solvents
9
Cutter Tooth
Guard Tooth
21
Publicidad
