Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
PROBLEM
CAUSE
◾
Hedge trimmer
doesn't work .
◾
◾
◾
◾
◾
◾
◾
Excessive
vibration or
noise .
◾
◾
◾
56V LITHIUM-ION CORDLESS HEDGE TRIMMER — HT2400/HT2400-FC
The battery pack is not
attached to the hedge trimmer .
No electrical contact between
the trimmer and battery
The battery pack is depleted .
The battery pack is too hot .
The hedge trimmer is too hot .
The two switch levers are not
depressed simultaneously .
The blade is jammed .
Dry or corroded blades .
Blades or blade support is bent .
Bent or damaged teeth .
Loose blade bolts .
SOLUTION
◾
Attach the battery pack to the hedge
trimmer .
◾
Remove battery, check contacts and
reinstall the battery pack .
◾
Charge the battery pack .
◾
Remove the battery pack from the tool
and allow it to cool until the temperature
drops below 152°F (67°C) .
◾
Release both switch levers; allow the
trimmer to cool until the temperature
drops below 170 .6°F (77°C) .
◾
Depress the switch levers on the front
and rear handle simultaneously .
◾
Remove the battery pack from the tool,
remove the obstruction carefully, then
reinsert the battery and restart the tool .
◾
Lubricate the blades, following the
section "LUBRICATING THE BLADE"
found in this manual .
◾
Replace with a new blade or support .
Contact EGO service center for blade or
support replacement service .
◾
Replace with a new blade . Contact EGO
service center for blade replacement
service .
◾
Tighten the blade bolts . Using a 5/16"
wrench, turn the bolt clockwise to tighten .
23
Publicidad
