Publicidad
Idiomas disponibles
Idiomas disponibles
Before Requesting Service
fTThese things are normal:
The oven causes
interference with
my TV.
Some radio and TV interference might occur when you cook
with the microwave oven. This interference is similar to the
interference caused by small appliances such as mixers,
vacuums, blow dryers, etc. It does not indicate a problem with
your oven.
Steam accumulates
on the oven door and
warm air comes from
the oven vents.
During cooking, steam and warm air are given off from the
food. Most of the steam and warm air are removed from the
oven by the air which circulates in the oven cavity. However,
some steam will condense on cooler surfaces such as the
oven door. This is normal. After use, the oven should be
wiped dry (see page 22).
/
_PROBLEM
Oven will not start
cooking.
The Glass Tray
wobbles.
When the oven is
operating, there is
noise coming from
the glass tray.
The word "Child"
appears in the
Display Window.
c,us l (
1
The oven is not plugged in
Remove plug from outlet, wait
securely.
10 seconds and re-insert.
ICircuit breaker or fuse is
Reset circuit breaker or replace
[,tripped or blown,
fuse.
IThere is a problem with the
Plug another appliance into the
loutlet,
outlet to check if it is working.
The door is not closed
Close the oven door securely.
completely.
was not pressed
Press Start Pad.
after programming.
Another program is already
Press Stop/Reset
Pad to cancel
entered into the oven.
the previous program and enter
new program.
The program is not correct.
Program again according to the
Operating Instructions.
Stop/Reset
Pad has been
Program oven again.
pressed accidentally.
The Glass Tray is not
Take out Glass Tray and Roller
positioned properly on the
Ring. Wipe with a damp cloth and
Roller Ring or there is food
reset Roller Ring and Glass Tray
under the Roller Ring.
properly.
The Roller Ring and oven
Clean these parts according to
bottom are dirty.
Care and Cleaning of your
Microwave Oven (see page 22).
The CHILD LOCK was
Deactivate LOCK by pressing
activated by pressing
Stop/Reset
pad 3 times.
Start pad 3 times.
23
Publicidad
