into place
when d6or handles are remove&
property
following:
> Refrigerator panels should not
weigh more than
kilograms) and fr_
should not weigh
pounds(7 kilogra
> Protect soft vinyl
with cardboard, n
protective material.
> Protect hands and arms by
wearing gloves.
NOTE:
> To protect door surfaces from being
scratched, cover back edges of
decorator panels by placing masking
tape along back edges.
>- Save all screws and reuse in original
locations.
Y4"(6 mm) Panel Dimensions
Extended
Door
Panel
Fresh food
door
Upper
dispensing
freezer door
Lower
dispensing
freezer door
Non-
dispensing
freezer door
Panel
Panel
Height
Width
66 T'4"
18 _'A6"
(169.5 cm)
(48.1 cm)
18 1/8"
13 _sAs"
(46 cm)
(36.4 cm)
32 %2"
13 1_/i,"
(61.5 cm)
(35.4 crn)
66 ¾"
13 1_,6"
(169.5 cm)
(35.4 cm)
INSTALLING PANELS
1. Removetop trim screws with a
Phillips screwdriver and remove top
trim.
.
,
.
,
.
Slide handle upward until
loose. Remove handle
from door.
Removedoor
retainer clips with
a ¼"hex head
driver.
Slide bottom of panels into bottom
door trim until hinge side of decorator
panel rests under hinge side trim.
REMOVING PANELS
1. Remove top trim screws with a
Phillips screwdriver and remove top
trim.
.
.
IMPORTANT: Tapetops of panels to
4.
door to prevent panels from falling.
Reinstall door
r__
5.
retainer clips with
a ¼" hex head
driver.
Reinstall handle by inserting retaining
clips on door into notches on back of
handle.
IMPORTANT: Tape tops of panels to
door to prevent panels from falling.
> Slide handle down until it contacts
bottom trim.
7. Remove tape from
tops of panels
before reinstalling
top door trim with
Phillips screws
removed in step 1.
Slide handle upward until
loose. Remove handle
from door.
Remove door
retainer clips with
a ¼" hex head
driver.
Remove tape to slide panels out of
door trim.
Refer to steps 5, 6 and 7 of
Installing Panels to install handles
and trim.
m
9