the range above the cooking surface, a Thermador
Low Back or Pot and Pan Shelf must be installed. (See
Figure 2). When clearance to combustible material A
is over 12", a Thermador Flush Island Trim may be
used. Figure 2 indicates the space required for each
type of backguard.
Always keep appliance area clear and free from
combustible materials, gasoline and other flammable
vapors and liquids.
Do not obstruct the flow of combustion and ventilation
air to the unit.
A five (5) inch minimum clearance is needed when the
range is installed beside a combustible side wall.
A As defined in the "National Fuel Gas Code' (ANSI
2223.1, Current Edition).
For 30" Ranges
{ 3
30" or 36" Wide Hood
6" or 42" for Island
®
36" or 42" Wide Hood
—__
For $6" Ranges { 45» or 48" for Island
8
48", 54" or 60" Wide Hood
For 48" Ranges {ea for Island
I
]
A
Min. Distance Between Overhead Cabinets
0)0
of Combustible Material A
30" Range — 30"
>
be
36" Range
- 36"
43" Max.
48" Range
— 48"
Cabinet
17%
30" minimum from bottom of
Depth
A
CAUTION:
overhead Hood to cooking
/
See Figure 2
surface (36" min. if hood
5" Min. to
36" Min. to
4"
contains combustible
Range width
~ |
combustible
combustible
Min.
materials A. )
<
30", 36" or 48"
" |<- side wal->
material A
material A
from cooking
(both sides)
surface
Cooking
\
Surface
===-f5------------
Ne
ee ee ee
-5
Co
For Electrical and Gas Supply Zone, see
|
Figure 3A.
ee
*35-7/8" Min. Range Height
with Leveling Legs fully
retracted
A
as defined in the "National Fuel Gas Code" (ANSI Z223.1,
*36-3/4" Max. Range Height
with Leveling Legs fully
extended.
countertop level.
Current Edition).*The range height is adjustable. The level
of the range top must be at the same level or above the
Figure 1: Cabinet Clearances
English 5