Urmet 9854/58 Manual De Usuario Y Instalacion página 15

3. Secure the device to the base in the
recommended position.
4. The local power supply must be installed in the
electric panel or a cabinet.
5. Connect the device to the system and to the
power supply provided.
The end of a stranded conductor must
not be consolidated with mild soldering
in the points in which the conductor is
subject to contact pressure.
6. Carry out the device configuration by means of
jumpers and/or dip-switches.
7. Replace the terminal strip cover on the device
(the second transparent cover should not be
used because it prevents cover closing.)
8. Power on the device.
9. Complete your parameter configuration by
using the Urmet CallMe App.
10. Install the cover.
DS9854-005D
If, at a later stage, it becomes necessary
to remove the cover use a screwdriver in
the indicated points.
2
2.3. DESCRIPTION OF
COMPONENTS
Call Forwarding device for 4+N
1 2 5 3
1. STATUS LED: LED showing the state of your
Internet connection.
• flashing red light: the device is turned on in
the configuration mode;
• steady green light: the device has been
correctly registered with the Urmet SIP
server and is ready to forward calls to a
smartphone;
• flashing green light: the device is in Upgrade
mode;
• steady red light: the device is showing that
there is no Internet connection;
• steady orange light: device not enabled (no
active Wi-Fi.)
During power-on or after pressing
the PROGR/RESET key, the device
1
2
1
4 6 7 8 9 10
15