Craftsman 286.17589 Manual Del Operador página 18

Idiomas disponibles

A'I-rACHING REPLACEMENT BLADES TO THE SAW (See Figs. 17 - 20)

,/_ WARNING:

ThisTwin Cutter saw uses specially designed5-in. blades

and no other types or sizes of blades shouldever be used. Other types and sizes

of.blades will not operate safely in this saw and could result in serious personal

injury.

See the accessories section of this manual for the proper replacement blades

that are needed for this saw.

1, Unplug the saw,

,/_ WARNING:

Failureto unplugthe saw could result in accidentalstarting

causing possibleserious personalinjury,

2, Lay the saw clown with the blade arbor pointingupward.

3, Place blade"A" onto the bladeflange with the "A" clearlyvisible (see Fig. 17).

4. Align the holes on the blade with the pinson the flange and securely fitthe blade

on the flange (see Fig, 18),

5. Take the arbor adapter "1" and push it down onto the flange with the "1" clearly

visible.Make sure that the adapter is properly seated over the flat sides of the

flange.(see Fig, 18),

6, Place blade "B" onto the adapter with the "B" easily visible,then thread lock nut

onto shaft. DO NOT tighten, (see Fig. 19).

7. Turn the blades so that the holes in both blades are lined up.

Flange

Fig. 18

Fig. 19