Xylem JABSCO 36600 Serie Manual De Instalación Y Funcionamiento página 2

Electric Bilge Pumps — Model 36600-Series
FEATURES
• Self-Priming
• Diaphragm Design Allows Dry Running
• Quiet Operation
• Built-In Hydraulic Pulsation Dampener
• Permanently Lubricated Ball Bearings on Shaft and Connecting
Rod
• Large Vibration Absorbing Pads
• Corrosion Resistant Materials Throughout for Sea Water Service
• Meets USCG Regulation 183.410 and ISO 8846 MARINE for
Ignition Protection
SPECIFICATIONS
Open Flow:
Vert. Dry
Suction Lift:
Ports:
Weight:
Standard Models
Model No.
36600-0000
36600-0010
APPLICATION
Jabsco diaphragm bilge pumps are self-priming, so they can be
mounted above and outside of harsh bilge environments. Because
they are mounted remotely, the intake hose can be routed to the
lowest point of the bilge regardless of space limitations. They are
supplied with an in-line strainer to prevent damaging debris from
entering pump. The reliable diaphragm design is not damaged
by dry running.
MAINTENANCE
Winter Storage
When possible, it is preferred that the complete pump or at least
motor, diaphragm and valves be removed and stored in a warm
dry place. If this is not possible, the pump must be completely
drained, hoses removed and pump run until all water is expelled.
CAUTION: DO NOT USE AUTOMOTIVE
TYPE ANTI-FREEZE.
Mounting
Mount upright in a dry location (above highest bilge water
level) on a solid surface. Adjust belt tension for 1/4" (6mm) play
between pulleys.
8.0 GPM
10 feet (3 m)
3/4" Slip-on Hose
11 lb
Amperage
Voltage
Nominal
12 Vdc 11.0
24 Vdc 5.5
Plumbing
For intake and discharge use 3/4" (19mm) ID non-collaps-
ible hose. Keep intake and discharge lines free of kinks and
restrictions. Use the 3/4" (19mm) bilge in-line stainer (Model
36200-0000) in the intake line from the bilge to protect pump
from debris. Use a 3/4" (19mm) thru-hull fitting for discharge.
WIRING FOR DC VOLTAGE MODELS
See Figure 1
Wire pump in a circuit independent of all other electrical fixtures.
Use stranded copper wire. Install fuse/breaker in positive circuit.
See table for recommended wire and fuse size. See diagram for
wiring connections.
After installation, it is recommended that voltage be checked at
the motor terminals with motor operating under full load and all
other appliances in the circuit operating. Voltage should not be
less than 90% of rated motor voltage.
WARNING: FIRE HAZARD
Wiring must comply with applicable
electrical standards and include a properly
sized fuse or circuit breaker. IMPROPER WIRING CAN CAUSE A
FIRE RESULTING IN INJURY OR DEATH.
Figure 1
FUSE/
BREAKER
BATTERY
2
ON
OFF
AUTOMATIC
Automatic Bilge Switch
Rule Model 41/42
PUMP