Scheppach HS110 Traduccion Del Manual De Instrucciones Originale página 45

12.2 Replacing the table insert (Fig. 13)
m WARNING: In case of wear or damage, the table
insert (5) must be replaced; otherwise there is an in-
creased risk of injury.
1. Use a Phillips screwdriver (not supplied) to remove
the two countersunk crews of the table insert (25).
2. Remove the worn table insert (5).
3. Installation of the new table insert (5) takes place
in reverse order.
12.3 Carbon brushes
If excessive sparks are generated, have an electri-
cian check the carbon brushes. Attention! The carbon
brushes must only be replaced by an electrician.
12.4 Service information
Please note that the following parts of this product are
subject to normal or natural wear and that the following
parts are therefore also required for use as consum-
ables.
Wear parts*: Carbon brush, saw blade, table inserts,
push stick
* Not necessarily included in the scope of delivery!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
13. Storage
Store the device and its accessories in a dark, dry and
frost-proof place that is inaccessible to children. The
optimum storage temperature is between 5 and 30˚C.
Store the electrical tool in its original packaging.
Cover the electrical tool in order to protect it from dust
and moisture.
Store the operating manual with the electrical tool.
14. Electrical connection
The installed electric motor is connected ready
for operation. The connection complies with the
relevant VDE and DIN regulations. The customer's
network connection and any extension cable used
must comply with these regulations.
• The product meets the requirements of EN 61000-
3-11 and is subject to special connection conditions.
This means that use of the product at any freely se-
lectable connection point is not allowed.
• Given unfavorable conditions in the power supply
the product can cause the voltage to fluctuate tem-
porarily.
• The product is intended solely for use at connection
points that
a) do not exceed a maximum permitted supply im-
pedance "Z" (Zmax. = 0,429 Ω), or
b) have a continuous current-carrying capacity of
the mains of at least 100 A per phase.
• As the user, you are required to ensure, in consulta-
tion with your electric power company if necessary,
that the connection point at which you wish to oper-
ate the product meets one of the two requirements,
a) or b), named above.
14.1 Important Instructions
If the motor is overloaded, it switches itself off automat-
ically. After cooling down (times vary), the motor can be
switched on again.
14.2 Faulty electrical connection cable
Insulation damage often occurs to electrical connec-
tion cables.
The causes of this may be as follows:
• Pressure points if connection cables are routed
through windows or door gaps.
• Kinks caused by improper attachment or routing of
the connection cable.
• Cut surfaces caused by vehicles driving over the
connection cable.
• Insulation damage caused by tearing out of the wall
socket.
• Cracks resulting from the insulation becoming old.
Such faulty electrical connections must not be used
and may endanger life due to the damage to the in-
sulation.
Electrical connection cables should be checked regu-
larly for damage. Ensure that during such checks, the
connection cable is not connected to the mains.
Electrical connection cables must comply with the rel-
evant VDE and DIN regulations. Only use connection
cables with the marking.
It is stipulated by law that the type of connection cable
must be printed on it.
If it is necessary to replace the power cable this should
be done by the manufacturer or their representative to
avoid safety hazards.
www.scheppach.com GB | 45