cecotec IRONHERO 3200 FORCE ANODIZED Manual De Instrucciones página 40

ENGLISH
Problem
Not enough or too much
heat
No steam or leakage
Steam burst or vertical
steam are not working
Water leaks from the
soleplate
Little steam
Iron does not spray
40
IRONHERO 3200 FORCE ANODIZED
Cause
You have not turned the
temperature/thermostat knob
correctly or the iron is not correctly
plugged in.
The temperature/thermostat knob
has been set to the MIN position.
The steam burst function (vertical
steam) has been used too often in a
very short period of time. The iron is
not hot enough
You have set the steam switch
outside the steam range.
The heat is still not enough.
Water is above the maximum
position.
Check if the steam switch is in the
correct position.
The steam outlet orifice is blocked.
There is little water in the water
tank.
Not enough pressure or air inside.
Solution
Correct the position
of the temperature/
thermostat knob and
check if the iron is
correctly plugged in.
Turn the temperature/
thermostat knob to
select the desired
temperature.
Continue ironing in
horizontal position and
wait for a while before
using the (vertical) steam
burst function again.
Set the steam switch
within the steam range.
Press the steam button
only after the indicator
light goes out
Pour in the remaining
water.
Set the steam switch to
the correct position.
Clean the steam outlet
orifice with distilled
water.
Fill up the water tank.
Press the spray nozzle
with your hand and press
the spray button several
times continuously.