Uline H-3704 Manual Del Usuario página 2

Figure 1
48 in
13.5 in
MACHINE PLACEMENT
Place the high profile turntable close to an area where
you will be wrapping your pallet loads. Make sure that
there is sufficient room to load/unload the machine and
that you do not stretch the wiring cable. Remember,
you will need to provide electrical service to a 120VAC,
15 amp outlet.
FLOOR WEIGHT BEARING TOLERANCE
The floor must be able to bear the weight of the
machine, the weight of the maximum load, plus a
safety factor. The floor must also be able to tolerate
the stress of the machine's operation. If the fork trucks
will operate on the same weight bearing area, add
the weight of the trucks to the weight bearing stress
tolerance requirements.
PAGE 2 OF 24
SYSTEM DESCRIPTION
60 in
SYSTEM SETUP
MACHINE SETUP
1. Place skidded machine close to the designated
wrap area. Remove all shipping fasteners holding
the machine to the pallet.
2. Place forks of the forklift through the tubes
provided at the rear base of the module, remove
the machine from these skids and place it at the
designated wrap area.
0721 IH-3704