Publicidad
Idiomas disponibles
Idiomas disponibles
Washer
does not operate:
• Check if unit is plugged in. The plug may have come loose.
• Check if the electrical wall receptacle has proper voltage.
• Check if the circuit breaker needs to be reset or if the fuse needs to be
replaced.
• Check if the unit is in "Off" mode.
• Check if the washer is overloaded: load may need to be re-balanced
and
clothes may need to be redistributed.
• Check if the door is open. You may have to close the door properly.
Problems
with
water:
• Not enough
water
coming
out: Water faucet
may need to be turned
on fully.
Water hoses may be tangled
up or wrinkled
up. Straighten
up hoses.
Check
water
level selection,
it may need to be readjusted.
• Water Temperature is incorrect: Check your water heater temperature.
Hot
water needs to be at a temperature at least 120°F-140°F
(49°C - 60°C).
Check to make sure the inlet hoses are properly connected. (e.g. hot to hot &
cold to cold)
• Water leaks: This is due to not improperly
installed
drain
hose or fill hoses.
Your home
drain
may be clogged.
You may need to tighten
hoses, check the
plumbing
or call a plumber
for service.
• Water pumped out before the cycle is completed: It happens if you open the
door in the middle of cycle.
• Water will not drain: This may be because drain hose was not installed
properly. Check the position of the drain hose. In order to drain properly, make
sure that top of drain outlet is less than 4 ft. (] .2 m) above the floor.
2O
Publicidad
