Publicidad
Idiomas disponibles
Idiomas disponibles
U pocki g
Your Unit
Warning:
To reduce the risk of fire, this appliance must be fastened or otherwise
secured to an uncovered floor.
• As shown in Fig. 1, remove all the packing materials (including the foam
base), it is normal that there are some water drops on the plastic bag, the
cushion and the porthole, it is because of the water testing before leaving the
factory.
• Remove the packing screws as shown in Fig.2.
The packing bolts protect the appliance from impact damage during
transportation.
Follow the steps below before using the appliance.
1. Remove the rear panel of the washing machine.
2. Remove the three packing bolts from the rear panel of the washing
machine, the rubber hose and then the shock absorption steel channel.
3. Refit the back plate.
4. Fill the left holes by the packing bolts with plastic plugs.
Attention:
The packing bolts and rubber hose should be kept in a safe place
for later use.
There is a plastic jacket packing the door catch. Please remove it when you
unpack the machine. Do not let children touch.
• Adjusting the position of the washing machine:
The washing machine is provided with adjustable feet. Before use, adjust the
feet until the appliance is leveled, as shown in Fig. 3.
Co ectio
of wote
i lllllet Bose
wosBi g
_OC_i_@
(Use new hose-set, old hose-set should not be reused.)
• Connect the straight terminal of the inlet hose to the water tap and make sure
that it is fastened.
• Connect the bended terminal of the inlet hose to the solenoid valve and make
sure it is fastened.
• Be sure that the COLD inlet hose is connected with the solenoid valve for cold
water (marked with "C"), the HOT inlet hose is connected with the solenoid
valve for hot water (marked with "H").
• For easy recognition,
Red line refers HOT inlet hose.
Publicidad
