Descargar Imprimir esta página

Kenmore ELITE 79041039803 Instrucciones De Instalación página 10

Estufa de fuel dual de 30"

Publicidad

Idiomas disponibles

Idiomas disponibles

30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
(Models with an Electric Oven and a Gas Cooktop)
Range Installation
important Note: Door removal is not a requirement for
installation of the range, but is an added convenience.
Refer to the Use and Care Guide for oven door removal
instructions.
Standard
Installation
The range cooktop overlaps the countertop at the
sides and the range rests on the floor. The cooktop
is 31 1/2" (81 cm) wide.
©
Install base cabinets 30" (76.2 crm) apart. Make sure
they are plumb and level before attaching cooktop.
Shave raised countertop edge to clear 3%" (81 cm)
wide range top rim.
>
Install cabinet doors 31" (78.7 cm) min. apart so as
not to interfere with range door opening.
>
Cutout countertop exactly as shown on page 1.
@
Make sure the four leveling legs (front and rear) are
setup higher than the height of the cabinet (shown
on page 3).
@
Nee
Install the anti-tip bracket at
this point before placing the range at its final
position. Follow the installation instructions on
page 13 or on the anti-tip bracket template supplied
with the range.
>
To provide an optimum installation, the top surface
of the countertop must be level and flat (lie on the
same plane) around the 3 sides that are adjacent
to range cooktop.
Proper adjustments to make
the top flat should be made or gaps between the
countertop and the range cooktop may occur.
[>
NOT
To reduce the risk of damaging your
appliance, do not handle or manipulate it by the
ceramic glass. Manipulate with care.
10
&
Position range in front of the cabinet opening.
@
Make sure that the cooktop which overhangs the
countertop clears the countertop. If necessary, raise
the unit by lowering the leveling legs.
@
Level the range (see section 8). The floor where
the range is to be installed must be level. Follow the
instructions under "Leveling the Range".
@
Slide the range into the cutout opening.
Wizecartee
if Accessories Needed
installation With Backguard
The cutout depth of (21 3/4" (55.2 cm)Min., 22 1/8"
(56.2cm) Max.) needs to be increased to 24" (61 cm)
when installing a backquard.
installation With End Panel
A End Panel kit can be ordered through a Service
Center.
Installation With Side Panels
A Side Panels kit can be ordered through a Service
Center.
Install cabinet doors 31" (78.7 cm) min. apart so as
not to interfere with range door opening.

Publicidad

loading

Este manual también es adecuado para:

Elite 79041032803