Descargar Imprimir esta página

Kenmore ELITE 79041039803 Instrucciones De Instalación página 3

Estufa de fuel dual de 30"

Publicidad

Idiomas disponibles

Idiomas disponibles

30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
(Models with an Electric Oven and a Gas Cooktop)
Models with glass cooktop - To avoid breakage: DO NOT handle or manipulate
the unit by the cooktop glass.
The counter-top around the cut-out should be flat and leveled (see
hatched area on illustration 1).
Before installing the unit, measure the heights of the two (2) cabinet
sides (H1-4), front and back (see illustration 1) from the floor to the top
4)
of the counter.
Level the range using the
Shave
1%" Max.
four (4) leveling legs so
Raised
(3.8 cm Max.)
that the height from the
Edge
=)
floor to the underside of
to Clear
the cooktop glass is greater
than the tallest cabinet
31%" (81 cm) Wide
Space for a
measurement by at least
Cooktop.
1/16" (see illustration 2).
Slide the unit into the cabinet. Make sure the
center of the unit is aligned with the center of
the cabinet cut-out.
lustration 1
Remove the protective channels on each side of the glass
cooktop (if provided).
The metal flange under each side of the cooktop MUST be placed
over the cabinet countertop for proper unit support. The glass cook-
top should NOT directly touch the countertop (see illustration 2) or
could cause glass breakage voiding the warranty. Level the unit if
needed.
~ To successfully install
the range, the initial
level height from
floor to underside of
cooktop glass should
be at least 1/16"
taller than cabinet
sides as measured in
step 1.
>
After the installation, MAKE SURE that the unit is
supported by the leveling legs NOT by the cooktop.
llustration 2

Publicidad

loading

Este manual también es adecuado para:

Elite 79041032803