Publicidad
Idiomas disponibles
Idiomas disponibles
30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
(Models with an Electric Oven and a Gas Cooktop)
. Remove the 3 loose nuts (after you remove the
rubber band) on the terminal block using a 3/8" nut
driver or socket.
. Connect the neutral white wire of the copper power
supply cord to the center silver-colored terminal of
5. Connect the neutral of the copper power supply
cord to the center silver-colored terminal of the
terminal block, and connect the other wires to the
outer terminals. Match wires and terminals by color
(red wires connected to the right terminal, black
the terminal block, and connect the other wires to
the outer terminals. Match wires and terminals by
;
color (red wires connected to the right terminal,
6. Replace the 3 nuts on the terminal block (see Figure
black wires connected to the left terminal).
4).
4. Replace the 3 nuts on the terminal block. (See Figure
7. Lower the terminal cover and replace the 3 screws.
3)
5. Lower the terminal cover and replace the 3 screws.
wires connected to the left terminal).
Terminal Block
Silver Colored
Silver colored Terminal
Red
Wire
Red wire
en
Black Wire
sus
ie
@
I
1-1/8" Dia. —
as
[X
;
Direct
ae
SN
/ \
Terminal
Connection
ra
ay
Block
Hole. Punch
i
A
(Neutral)
out knockout
Ground
for 1-3/8" Dia.
Lo
(Bare Copper
Cord Kit Hole
Co
or Green
(Neutral)
Wire)
Grounding
A strainrelief
supplied by the user
Strap
.
must be installed at
To 240 V receptacle
this location
NOTE: Be sure to remove the supplied
f
Astrain relief
grounding strap
—_———
supplied by the user
1-1/8" Dia. Direct
Figure 4
receptacle
1-3/8" Dia. Cord Kit Hole
Direct Electrical Connection to the Circuit
Figure 3
Breaker, Fuse Box or Junction Box
If the appliance is connected directly to the circuit
Four
Conductor
Wire
Connection
to Range
breaker, fuse box or junction box, use flexible, armored
or nonmetallic sheathed copper cable (with grounding
wire). Supply a ULL. listed strain-relief at each end of
the cable. At the appliance end, the cable goes through
the Direct Connection Hole (see Figure 4) on the Cord
Mounting Plate. Wire sizes (copper wire only) and
connections must conform to the rating of the appliance.
(mobile homes)
1. Remove the 3 screws at the lower end of the rear
wire cover, then raise the lower end of the rear
wire cover (access cover) upward to expose range
terminal connection block (see figure 2).
2. Remove the 3 loose nuts (after you remove the
rubber band) on the terminal block using a 3/8" nut
driver or socket.
3. Remove the grounding strap from the terminal block
and from the appliance frame.
4. Connect the ground wire (green) of the copper
Where local codes permit connecting the appliance-
grounding conductor to the neutral (white) wire
(see Figure 5):
(The 3-conductor cord or cable must be replaced with
a 4-conductor cord or cable where grounding through
power supply cord to the frame of the appliance
the neutral conductor is prohibited in new installations,
with the ground screw, using the hole in the frame
mobile homes, recreational vehicles or in other areas
where the ground strap was removed (see Figure 4).
where local codes do not permit neutral grounding)
1. Disconnect the power supply.
2. In the circuit breaker, fuse box or junction box
connect the appliance and residence cable wires as
shown in Figure 5.
Publicidad
