Publicidad
• Do not use it without the frontal grid correctly assembled.
• Do not put the fingers or other objects into the fan to prevent
the engine block.
• Manipulation or replacement of any component must be
performed by an authorized service centre.
• If the power cord is damaged, it must be replaced by the
manufacturer or by its after-sales service or similar qualified
personnel in order to avoid a danger.
ASSEMBLING INSTRUCTIONS
• Remove the "L" screw from the extensible tube (10) and insert it into the base, after that you can tight the
"L" screw.
• Loose the nut to fix the height and remove the extensible tube (10).
• Insert the head (6) to the extensible tube and fix it.
• Unscrew the nut to fix the propeller (8) clockwise and the grid nut (7) anticlockwise.
• Place the rear grid (4) into the motor shaft and fix it with the screw grid by turning it clockwise.
• Place the blade (1) into the shaft by pressing till the end and screw the guard cap (8) into the shaft
anticlockwise.
• Insert the frontal grid (5) and be sure all the guard clips are closed.
INSTRUCTIONS OF USE
• Remember the fan always must be placed on a flat and stable surface.
• Plug the appliance into the mains.
• To adjust the height loose the screw (11), place the fan into the desired height and fit the screw.
• Move the air flow by turning the head or moving up and down the head till getting the desired position.
• Push the oscillation knob to active the oscillation function (9).
• Raise the oscillation knob to stop this function.
• Turn the speed selector (2) clockwise or anticlockwise, making coincide the desired speed position with
mark ( ):
Position 0 - Off.
Position 1 - Minimum speed.
Position 2 - Medium speed.
Position 3 - Maximum speed.
MAINTENANCE AND CLEANING
• Before you proceed to cleaning, make sure the appliance is unplugged from the mains.
• Clean with a slightly damp cloth.
• It is important to keep the frontal grid and the back grid clean of dust.
• You can disassemble the blades for cleaning by following the assembling reverse process.
• Do not use abrasive or chemical products, such as metallic scourers, which may deteriorate the surfaces of
the appliance.
ENVIRONMENT PROTECTION
• Dispose the appliance according to the local garbage regulations.
• Never throw it away to the rubbish. So you will help to the improvement of the environment.
ATTENTION
• Avant de mettre en marche le ventilateur, veuillez lire
attentivement cette notice et conservez-la pour vous y reporter
au besoin.
FRANÇAIS
8
Publicidad
