Publicidad
Idiomas disponibles
Idiomas disponibles
3. Insert the weight selector pin (21) through the weight stack (29) and secure it with the lock
pin 10*150 (68).
4. Slide the top weight plate (24) along the weight guides (22) and attach the large washer
∅
(
45) (27). Fig. 4
Step 3
1.
Attach the upright frame (5) to the main lower frame (1) and secure the assembly using the
reinforced plate (48), two M10x50 hexagonal bolts (74) washers and nuts. Fig. 5
Step 4
1.
Attach the top support frame (4) to the upright frame (5) and fix the assembly using a
reinforced plate (48) and two M10x50 hexagonal screws (74).
2. Attach the seat bracket (6) and the reinforced bracket (8) to the upright frame (5) and fix
the assembly using a reinforced plate (48), two M10x50 hexagonal bolts (74), one M10x45
bolt (75), washers and nuts.
3. Attach the upright frame of the abdominal bench (59) to the rear lower base (2) and secure
the assembly using the reinforced plate (48), two M10x50 hexagonal bolts (74) washers
and nuts.
4. Attach the top frame (66) to the top support frame (4), the top support frame to the weight
guides (22) and the upright frame of the abdominal bench (59) and secure the whole
assembly using 3 sets of screw and washer (78) and 2 sets of screw and washer (82). Fig. 5
Step 5
1.
Attach the T-shaped support bar (13) and pulley shaft (51) to the upright frame and secure
the assembly using M10x50 hex bolts (74), washers and nuts.
2. Attach the press arm bracket (10) to the top support frame (4) and secure the assembly
using M12x155 hex bolts (69), stainless steel bushings (42), washers and nuts.
3. Attach the seat pulley (32) to the pulley shaft (51) and secure it using M10x65 hexagonal
bolts (73), washers and nuts.
4. Attach the T-shaped screw (31) to the T-shaped support bar (13) and secure the assembly
using M8x45 hexagonal bolts (89), washers and nuts. Fig. 6
Step 6
1.
Attach the right press arm (12) to the press arm bracket (10) and secure the assembly
using stainless steel bushings (42), M12x80 hex bolts (70), washers and nuts.
2. Insert the handlebar arm (16) into the left and right press arms holes (12, 11) and secure it
using M10x20 hex screws (78) and washers. Fig. 7
Step 7
1.
Attach the leg extension bracket (7) to the seat bracket (6) and secure the assembly using
M10x75 hex bolts (72), washers and nuts.
DRUMFIT HOMEGYM 2000 DOUBLE
ENGLISH
43
Publicidad
