Lomography Diana F Plus Manual De Instrucciones página 8

INSTRUCTIONS FOR USE
LOADING THE FILM
Remove the Rear Door [2]. Insert the fresh film roll into the left side. The film spool has
holes on the top and bottom which will match with plastic posts on the top and bottom of
the camera. Pull the film across to the right side Take-up Spool [3]. You should only thread it
in a little bit – about a half-inch or two centimeters. With the Rear Door [2] still off, turn the
Advance Wheel [6] counterclockwise and ensure that the film is transporting and threading
smoothly by turning two or three complete revolutions. If you've got a lot of slack – or if the film
is transporting at an angle – then STOP, take out the film spool, and rewind it with your hands.
Then give it another try. If your film is loaded incorrectly, then it could scratch, fold, or break
inside your camera. Once you're sure that the film is properly loaded, put back the Rear Door
[2], turn the Rear Door Switch [1] to "Lock," and look through the small red window on the
Film Format Switch [4]. 120 film has its shot numbers printed on the back, so you can use this
window to count your exposures. As you advance, you'll see a fragment of the word "Start" and
then a sequence of symbols (usually a few circles or dashes that go from large to small) which
countdown to the first exposure of "1." Stop there, as you're now ready to shoot.
8