AEG BEB331010M Manual De Instrucciones página 27

Pizza Function
To bake pizza and other dishes that re‐
quire more heat from below.
Defrost
To defrost food (vegetables and fruit). The
defrosting time depends on the amount
and size of the frozen food.
7.2 Notes on: Moist Fan Baking
This function was used to comply with the
energy efficiency class and ecodesign
requirements (according to EU 65/2014 and
EU 66/2014). Tests according to: IEC/EN
60350-1.
The oven door should be closed during
cooking so that the function is not interrupted
8. ADDITIONAL FUNCTIONS
8.1 Cooling fan
When the appliance operates, the cooling fan
turns on automatically to keep the surfaces of
the appliance cool. If you turn off the
appliance, the cooling fan can continue to
operate until the appliance cools down.
9. CLOCK FUNCTIONS
9.1 Clock functions table
Time of Day
To set, change or check the time of day.
Duration
To set how long the appliance works.
Minute Minder
To set a countdown. This function has no ef‐
fect on the operation of the appliance. You
can set this function at any time, also when
the appliance is off.
9.2 Setting: Time of Day
1. - press repeatedly to change the time
of day. - flashes.
2. , - press to set the time.
and the oven operates with the highest
energy efficiency possible.
For the cooking instructions refer to "Hints
and tips" chapter, Moist Fan Baking. For
general energy saving recommendations
refer to "Energy Efficiency" chapter, Energy
saving tips.
7.3 Setting a heating function
1. Turn the knob for the heating functions to
select a heating function.
2. Turn the control knob to select the
temperature.
3. When the cooking ends, turn the knobs to
the off position to turn off the appliance.
8.2 Safety thermostat
Incorrect operation of the oven or defective
components can cause dangerous
overheating. To prevent this, the oven has a
safety thermostat which interrupts the power
supply. The oven turns on again
automatically when the temperature drops.
After approximately 5 sec, the flashing stops
and the display shows the time.
- flashes when you connect the appliance
to the electrical supply, when there was a
power cut or when the timer is not set.
- press to set the time.
9.3 Setting: Duration
1. Set a heating function and the
temperature.
2. - press repeatedly.
3. , - press to set the: Duration.
The display shows
the set time ends. The signal sounds and the
appliance turns off.
4. Press any button to stop the signal.
5. Turn the knobs to the off position.
,
- flashes.
. - flashes when
ENGLISH 27