Prusa Research MMU3 Manual Del Usuario página 106

PASO 35 Zip-Ties!
PASO 36 Apretando la funda textil
Gently twist the sleeve to tighten it up around the cables. Slide the sleeve towards
the extruder.
Take 3 zip-ties and insert them into the lower row of holes on the cable-holder.
Tighten up the sleeve around the cable bundle (without twisting the cables inside).
Hold it tight while you fix it in place with the zip ties.
IMPORTANT: Cut the remaining part of each zip tie using pliers as closest to its
head as possible. Note the correct position of each zip ties's head (pointing up)
106
9B. Mod extrusor MK3S+ (KIT)
Ensamblaje Original Prusa MMU3
Para los siguientes pasos, por
favor prepara:
Zip tie (7x)