Prusa Research MMU3 Manual Del Usuario página 132

PASO 15 MMU3 Firmware flashing (part 2)
Abre PrusaSlicer y selecciona Configuración ->Flashear Firmware Impresora en el
menú superior.
Haz clic en Buscar y selecciona el archivo de imagen del firmware MMU3 en tu
ordenador.
(por ejemplo MMU3_3.0.0.hex)
El puerto serie debería detectarse automáticamente.
Hit the Flash button.
Wait until the Flashing Succeeded! message appears.
After the flashing finishes, disconnect the USB cable.
In case of any issues with flashing the firmware please visit our
article.
PASO 16 MK3S+ Firmware image download
You will need to update both the firmwares for the printer as well as the MMU unit.
Use only a combination of the newest firmware versions for both devices together.
MMU3 requires a MK3S+ printer firmware 3.13 or newer!
If you are updating from a printer firmware 3.11 or older, the printer will require
you to do a
Visit help.prusa3d.com/downloads
This time, select ORIGINAL PRUSA i3 MK3S+ in the list and download the latest
FIRMWARE file.
132
10B. Configuración y Calibración MK3S+
thermal model calibration
Ensamblaje Original Prusa MMU3
first.
again
troubleshooting