Prusa Research MMU3 Manual Del Usuario página 13

PASO 9 Printed parts
If you prefer to print the plastic parts yourself, use the pre-sliced G-codes and print
all the required parts before proceeding with the assembly.
The printed parts must be printed perfectly in order for the MMU3 to work
correctly: no warping or lifted corners, stringing or other irregularities.
If you can't guarantee the parts being flawless, get the MMU3 kit with the
factory-printed plastic parts instead of printing it yourself.
En caso de que algunas piezas se rompan durante el montaje, puede volver a
imprimirlas. Verifica todas las piezas de plástico antes de comenzar su
construcción para asegurarse de que no haya problemas.
The MMU3 printable parts will be available at
parts/
The recommended material is PETG.
If you opt to slice the parts yourself, use PrusaSlicer with 0.2 mm layer height,
GRID infill at 20%. No supports are required.
1. Introducción
Ensamblaje Original Prusa MMU3
prusa3d.com/prusa-i3-printable-
13