Publicidad
Idiomas disponibles
Idiomas disponibles
Adjusting the Handle Height
You can raise or lower the handle in 1 of 2 positions that is
more comfortable for you
1. Loosen both handle knobs until you can push the
square edges of the carriage bolts out of the square
holes in the handle brackets.
2. Push the knobs until they are loose.
3. Move the handle to the upper or lower height position.
4. Pull the knobs until the square edges of each carriage
bolt fits into its related square hole.
5. Tighten the handle knobs as tight as you can.
(Figure
15).
Figure 15
Adjusting the Cutting Height
CAUTION
If the engine has been running, the muffler will be
hot and can severely burn you.
Keep away from the hot muffler.
Adjust the cutting height as desired. Set the front wheels to
the same height as the rear wheels
Note: To raise the machine, move the front cutting-height
levers rearward and the rear cutting-height levers forward.
To lower the machine, move the front cutting-height levers
forward and the rear cutting-height levers rearward.
g032867
1. Raise the machine
Note: The cutting-height settings are 25 mm (1 inch); 35
mm (1-3/8 inches); 44 mm (1-3/4 inches); 54 mm (2-1/8
inches); 64 mm (2-1/2 inches); 73 mm (2-7/8 inches); 83 mm
(3-1/4 inches); 92 mm (3-5/8 inches); and 102 mm (4 inches).
10
(Figure
16).
Figure 16
2. Lower the machine
g027451
Publicidad
