MotionBlinds CM-08-E Guía De Configuración página 25

Top-down/bottom-up setup with Pull (bottom rail)
2
Now set the end limits for the bottom rail (right motor) with the app or with the pull cord.
.1
When setting up the positions with the pull function make sure the USB-C cable is connected and
.2
powered (see page3). When your blind is positioned at your bottom position hold the end position
button until the blind moves up and down to save your bottom position.
Pull and hold the chain until the blind has reached the top position.
.3
WARNING: risk of damage. Slowly approach the top position. If the blind moves in the opposite
direction, release the chain and pull and hold again.
Adjust until the desired top position has been reached.
When your blind is positioned at your top position hold the end position button until the blind
.4
moves up and down to save your top position.
25