MotionBlinds CM-08-E Guía De Configuración página 26

Top-down/bottom-up with remote (middle rail)
1
Top-down/bottom-up blinds are powered by two motors: one for the bottom rail and one for
the middle rail. The motors need to be programmed individually: first the middle rail motor and
then the bottom rail motor.
To set the end limits for the top-down/bottom-up first lower the bottom rail and the middle rail
.1
to the bottom position. And start to setup the end limits of the middle rail (left motor).
Pair the middle motor to an empty channel on the remote. (see page 18)
26
Centre
Check the direction of rotation of the middle rail (see page 18) and move the middle rail to the desired
.2
bottom position. Simultaneously hold the centre and the up button on the remote until the blind stops
stepping and starts stepping again. The bottom position has been saved
Move the middle rail to the desired top position. Program the top position of the middle rail.
.3
Simultaneously hold the centre and the down button on the remote until the blind stops stepping and
starts stepping again. The top position has been saved
Up
Centre
Down