Publicidad
Idiomas disponibles
Idiomas disponibles
These cases require a deflection pulley anchored to
a fixed point and a rotation resistant wire rope.
The resistance of the pulley and its
anchorage must be verified.
The top limit switch security must be adapted:
contact us :
2.1.4 Power
The installer must ensure that the power supply is
compatible with the specification of the winch.
INSTRUCTION MANUAL
Electrical winches MOTRIX types 526&527
The power supply must be protected
upstream by a 30 mA differential switch. The
installation must be in accordance with EN 60204-
1. Power outlets must be calibrated to 16A.
The power cable to the MOTRIX control box must
be flexible cable (Class 5). Beyond 30m, it must be
held in place by a suitable anchorage clamp.
Maximum length of extension (m) :
Type :
1.5²
526J
180
527N
25
527B,
527E,
120
527D
If the MOTRIX winch is powered by a generator,
check that it delivers at least the voltage and power
required at the start of the winch (min 8kVA).
Note : the Motrix hoist can be powered with 3P+G
with the following restrictions and consequences :
- The tool plug can not function and must be
condemned
- F2 circuit breaker must be in the OFF position
- The power plug must be replaced by a
suitable model
2.1.4.1 Hoists connection
- Connect the button box to the socket on the
winch.
- Connect the main power plug to your
extension cord.
2.1.4.2 Commissioning
-
Unlock the emergency stop if
necessary
-
Press the UP button to lift or pull
the load
-
Press the DOWN button to lower
the load
If the hoist is not working, check that
the below securities are not activated:
Ref: 1813000210
Page: 9/21
Version: 42/22
Ref: 244547
2.5²
4.0²
6.0²
300
40
60
100
220
330
Publicidad
