Publicidad
Idiomas disponibles
Idiomas disponibles
2.2.1 Main dimensions
(depends according versions)
2.2.2 Safety devices
- A main brake acts on the engine in case of
power supply failure
- An upper limit switch sensor stops lifting
when the spring touches the switch.
- A lower limit switch sensor stops lowering
when the spring touches the switch.
- An electrical emergency stop placed on
pendant control acts immediately and stops
the winch to the ascent and the descent.
INSTRUCTION MANUAL
Electrical winches MOTRIX types 526&527
- A control of the load lifted by measurement
of the consumed current interrupts the rise
(except 527B); restart of the winch is
necessary.
- A
mechanical
simultaneous action of the up and down
commands.
- Electrical protection of the pendant control:
class 2 and IP67/69K.
- Fuse protecting the command, in the electrical
box.
- Hooks with safety latch.
- Manual brake lever (safe lowering)(except
527D)
The motor is protected against excessive warm-ups
by a probe inserted into the coil. This probe
prohibits operation by interrupting the control
circuit as long as the temperature of the coil is not
back to an acceptable value. In case of intensive
work or high duty, we suggest to allow a 15
minutes break every 30 minutes of work to avoid
overheating.
2.3
Description of the work or control station
"Up" and "down" hoist movements are controlled
from the pendant control.
Never stand under the load.
In case of a command error, wait for a complete
stop
of
motion
before
command. The control buttons are held type
buttons.
Limit stops are not operating devices but safety
devices. They should therefore not be used
voluntarily but only serve as shutoff devices in case
of involuntary exceedance of the expected travel.
Never stay or work under load. If necessary, have a
barrier of security on the floor around the area at the
vertical of the load.
Avoid heavy slipping: Wait for a complete
stop
of
your
installation
movement.
Check regularly that no obstacle is located along the
path of movement (above and below the load).
2.4
Normal use
This hoist is designed for lifting loads.
Ref: 1813000210
Page: 12/21
Version: 42/22
locking
prohibits
performing
another
before
resuming
the
Publicidad
