Makita UR014G Manual De Instrucciones página 13

To prevent the switch trigger from being accidentally
pulled, a lock-off lever is provided. To start the tool,
depress the lock-off lever and pull the switch trigger.
Release the switch trigger to stop.
1
Fig.8
► 1. Lock-off lever 2. Switch trigger
Speed adjusting
You can adjust the tool speed using the adjusting lever.
To adjust the tool speed, move the lever while depress-
ing the lock-off lever and pulling the switch trigger. To
increase the speed, move the lever toward you. To
decrease the speed, move the lever forward. When the
adjusting lever is in the most forward position, the tool
stops.
Fig.9
► 1. Adjusting lever
2
1
Reverse button
WARNING:
the battery cartridge before you remove entan-
gled weeds or debris which the reverse rotation
function can not remove. Failure to switch off and
remove the battery cartridge may result in serious
personal injury from accidental start-up.
This tool has the reverse button to change the direction
of rotation. By changing the direction of rotation, you
can change the direction in which the cut grass is flown.
The reverse button is also used for removing weeds
and debris entangled in the tool.
To reverse the rotation, press the reverse / high-torque but-
ton when the cutting tool is stopped. The reverse lamp lights
up. The cutting tool rotates in reverse direction when you
pull the switch trigger while depressing the lock-off lever.
To return to regular rotation, press the reverse / high-
torque button when the cutting tool is stopped.
1
Fig.10
► 1. Reverse lamp 2. Reverse / high-torque button
NOTE: If you press the reverse / high-torque button
while the cutting tool is still rotating, the tool comes to
stop and to be ready for reverse rotation.
High-torque button
You can use the tool in the high-torque mode. In the high-
torque mode, the tool speed is less likely to decrease than
in the normal mode when the load of the tool is large.
To use the tool in the high-torque mode, press and hold
the reverse / high-torque button. The high-torque lamp
lights up. To return to the normal mode, press and hold
the reverse / high-torque button again.
Fig.11
► 1. High-torque lamp 2. Reverse / high-torque button
13 ENGLISH
Switch off the tool and remove
2
1
2