Garant GRIDLINE 944520 Manual De Instrucciones página 12

GARANT GridLine laptop and battery charging cabinet
de
4.2.2. Battery charging cabinet
 For charging rechargeable batteries.
 Only charge batteries with the fan running.
en
 With 5-pin 400-V/16-A (3P+N+E) plug for connecting to three-phase outlet socket.
 Requires wall mounting.
bg
4.3. REASONABLY FORESEEABLE MISUSE
 Do not make any unauthorised changes or modifications.
 Do not use in potentially explosive atmospheres.
cs
 Not for use in areas where high concentrations of dust, flammable gases, vapours or solvents are present.
 Do not overload cabinet, drawers and storage shelf.
da
 Do not climb into or sit on cabinet, drawers or storage shelf.
 Do not place objects on cabinet shell that will extend beyond its edge.
4.3.1. Battery charging cabinet
es
 Keep fan and ventilation slots clear and uncovered.
 Do not by-pass the fuses.
fi
4.4. QUALIFICATIONS OF PERSONNEL
Specialists for mechanical work
Specialists in the sense of this documentation are persons who are familiar with assembly work, mechanical installation,
fr
commissioning, troubleshooting and maintenance of the products and who possess the following qualifications:
 Qualification / training in the field of mechanics as specified in the nationally applicable regulations.
Trained specialist for electro-technical work
it
A trained electrician in terms of this document is a person who has been respectively trained and who possesses the skills
and experience to recognise and avoid the dangers of working with electricity.
hr Trained person
Trained persons in the sense of this documentation are persons who have been trained to perform work in the areas of
transport, storage and operation.
hu
4.5. TRANSPORT
i
Immediately on receipt check the product for damage in transport. If the product is damaged, do not install or commission
lt
it.
Pallet delivery. Transport on pallet using suitable lifting gear. Do not lift cabinet off pallet alone.
nl
NOTICE
Improper transport
Damage to transport items.
no
» Do not drag them across the floor.
» When items of packaging are being transported they must be upright, secured with ropes and protected against slip-
ping.
pl
» When putting them down, do so slowly and evenly.
» Do not remove the transport packaging until immediately before installation.
pt
5. Setting up
 Set up on a solid, level floor with maximum load-bearing capacity.
ro
 Ambient temperature: -10 °C to +40 °C.
5.1. BATTERY CHARGING CABINET
 Use spirit level to check horizontal levelling. If necessary, adjust adjustable base [} Page 12] or use shim wedges.
ru
 Size 1000/DE and 1250/DE: Maintain a gap of at least four cm between cabinet rear and wall.
5.1.1. Adjusting adjustable base
sv
A
sk
sl
12