Garant GRIDLINE 944520 Manual De Instrucciones página 14

GARANT GridLine laptop and battery charging cabinet
de
6.3. REMOVING THE DRAWERS
E
en
6.4. INSERTING THE DRAWERS
F
bg
1. Pull the drawer runners out to their full extent and secure them.
2. Insert the drawer and push it in until you sense resistance.
3. Lift the drawer up and push it over the resistance until it is fully inserted on the rails.
cs
4. Swing the locking mechanism down and push it to the back.
6.5. MOVING SLIDES
da
G
ü Drawers removed.
1. Push a slot-head screwdriver between the cabinet wall and the guide rail.
es
2. Carefully push the slot-head screwdriver off the cabinet wall to prise off the guide rail.
3. Lift off the guide rail.
fi
4. Working from above, insert the guide rail into the hole in the desired position.
7. Commissioning
fr
7.1. LAPTOP CABINET
1. Insert the mains plug into a mains socket.
7.2. BATTERY CHARGING CABINET
it
1. Plug 5-pin 400-V/16-A connector into three-phase outlet socket.
2. Switch on main switch.
hr
8. Maintenance
Interval
hu
Once a week in rooms with nor-
mal levels of air pollution
Once a day in rooms with heavily
lt
polluted air
nl Before the start of each shift
no
pl
Occasionally
pt
Tab. 1: Maintenance activities
9. Rectification of faults and malfunctions
ro
Fault
Socket strips are unpowered. Mains plug not plugged in.
ru
sv
sk
sl
14
Action
1. Remove cover panel with a standard
screwdriver.
2. Clean filter.
3. Put cover panel back in place.
» Cover panel engages.
Check for external signs of damage, for de-
fects and for good condition. Check the
edges and guides for signs of wear.
1. If defective, immediately block access
and prevent use.
2. Have the damage repaired immedi-
ately.
Grease any locks and wheels with multi-
function oil.
Possible cause
Fuse tripped.
No power supply.
Performed by
Trained specialist for electro-technical
work
Trained person
Trained specialist for mechanical work
Action
Unplug mains plug and plug
in again.
Reset fuses.
Switch on main switch.
Switch on on/off switch on
socket.
Performed by
Trained specialist for electro-
technical work.