Descargar Imprimir esta página

cecotec FREEGO WASH TWICE SPRAY Manual De Instrucciones página 22

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
ENGLISH
remove the right-hand cover, take the rotary-brush head, and remove it pulling it outwards as
shown in Figure 6. To re-install it, follow the reverse procedure.
4. OPERATION
Charge indicator light
-
During operation, the indicator will light up red, and the appliance will stop working when
battery is low.
-
Once plugged to the mains, if the indicator lights up red, it means that the appliance is
charging. When the indicator changes from red to green, the appliance is fully charged.
-
If the appliance is not unplugged, it will stop charging, and the indicator will stay green to
remind you that the battery is charged.
-
Charging time is 4-5 hours. Once fully charged, unplug the appliance from the mains.
Please note
The appliance battery will not be charged on first use. The appliance can be used normally
after a first full charge. During the first 3 uses, it is recommended to charge the battery for
approximately 12 hours. The appliance will work normally after fully charging it and discharging
it.
Using the electric mop
1.
Remove the appliance from the charging base and press the power button on the handle
to switch the mop on.
2.
Hold down the Spray button to spray water through the front nozzle of the rotary brush.
Spray the floor and clean it with the front rotary brush, then dry it with the rear rotary
brush. Release the Spray button to stop spraying water.
Using the appliance
After using the appliance, place the support on the floor. Align the bottom of the appliance with
the support, place it in the slot, and leave the appliance upright.
Fig. 7
Please note
After use, the appliance should be placed on the support to prevent the wet bristles of the
rotary brush from touching and, in turn, damaging the floor.
42
FREEGO WASH TWICE SPRAY
5. CLEANING AND MAINTENANCE
Cleaning the waste-water tank Fig. 8
Remove the top cover and the waste-water tank, use a brush to clean the dirt from the floor-
brush holder, lift the waste-water tank, turn the handle, and pull it out. Open the water inlet
and empty the waste-water tank. Rinse the waste-water tank with clean water and reinstall
it in the appliance. If you have difficulty removing the waste-water tank, there may be some
dust or dirt particles between the tank and the brush base. It is recommended to clean the dirty
floor-brush base and the waste-water tank.
Notes
We recommend cleaning the waste- water tank after every use.
If you notice that water stains on the floor do not dry up when using the appliance, check that
the waste-water tank is not full. If full, empty and clean it before use.
Once the waste-water tank has been removed, it is normal for the brush base to be wet. Dry it
in a well ventilated place.
When installing the rotary brush, push it in all the way, then install the cover. If it is not properly
installed, the appliance will make unusual noises when turned on. If this occurs, stop using the
appliance immediately and re-install the rotary brush.
Please note
During the operation of the rotary brush, if there are too many objects, too many fibres are
entangled, or even a child has accidentally reached in, the rotary brush will stop rotating and
the appliance will automatically switch off as a safety measure.
Rotary brush
Manual cleaning
Follow the instructions in the "Installing and removing the rotary brush" section to remove the
brush. Clean it manually and then install it in the floor's brush. Fig. 9
Self-cleaning. Fig. 10
-
Place the appliance in the support and hold down the Spray button for 5 seconds; the red
light will blink and the rotary brush will enter self-cleaning mode. The rotary brush will
spin, the pump will spray water for 40 seconds and then will stop for 20 seconds, repeating
these cycles every 2 minutes.
-
Press any button to stop cleaning.
-
Because the nozzle is located at the front of the appliance, self-cleaning mode will only
clean the front rotary brush.
-
To clean the rear rotary brush, switch both brushes so that it can be cleaned at the front
part.
ENGLISH
FREEGO WASH TWICE SPRAY
43

Publicidad

loading

Este manual también es adecuado para:

04552