Descargar Imprimir esta página

Panasonic PanaFync/Pro PL70i Manual De Instrucciones página 12

Publicidad

Idiomas disponibles

Idiomas disponibles

Self-Test menu (No Signal screen)
This display indicates that the monitor is operating normally. When one of the following
conditions occurs, press one of the 4 operation keys to call the appropriate display.
No
Signa!
fH --.--kHz
fV --.-~
Hz
No signal ( the computer is not connected,
the mains power to the computer is
disconnected or the input connector in
use may be deselected, see Page 13
Error
fH
105.0kHz
fV
80.0
Hz
The horizontal or vertical sync. signal are
outside of the permitted range (the value of
the horizontal sync. signal will be displayed
in red and the value of the vertical sync.
Signal for instructions.)
signal will be displayed in white.)
Adjustment menu
O
Contrast : Adjust the screen contrast to match the brightness level in the room.
Pressing the [2] key toggles between brightness and contrast.
Even if the menu screen does not appear, the contrast can be adjusted by
pressing the [4 or P) key. If the [4 and È) keys are pressed at the same time,
the maximum level (100) will be set.
==
á-
se
asc
csc sc
a
sas
a
e
A
Y
ae
i
A
i
ei
a
o
X% Br ightness . Adjust the brightness to match the brightness level in the room so that the
level will be easy to see. Pressing the (2] key toggles between contrast
and brightness.
Note: If the [€ and P keys are pressed at the same time on the
Brightness adjustment screen, the standard level (50) will be set.
Size & Pos. :
Press the [2] key to select the zoom / horizontal position / horizontal size /
vertical position / vertical size adjustments.
Press the [1] key to save the adjustment.
Y
ZOOM : Both the horizontal and vertical size of the image can be adjusted at the
same time; however, the aspect ratio cannot be changed.
Press the [4 key to make the image smaller, the Bl key to make it larger.
H. Position : The horizontal position of the image can be adjusted.
Press the [d key to move it to the left, the P) key to move it to the right.
[=] H. Size : The horizontal size of the image can be adjusted.
Press the [4 key to make the image smaller, the BP] key to make it larger.
Note: Setting the image in the center of the screen to start will make the
adjustment easier.
V. Position
: The vertical position of the image can be adjusted.
Press the [d key to make it downward, the &J key to move it upward.
[1] V. Size : The vertical size of the image can be adjusted.
Press the Ed key to make the image smaller, the È] key to make it larger.
Note: Setting the image in the center of the screen to start wil! make the
adjustment easier.
==

Publicidad

loading

Este manual también es adecuado para:

Tx-d7s55