Publicidad
Idiomas disponibles
Idiomas disponibles
Adjustment menu
Moire reduction : Moire patterns are caused by interference of the CRT dot pitch and video
signal due to the resolution of the input signal, video pattern, etc.,
producing patterns of horizontal stripes (Horizontal moire pattern) or
vertical stripes (Vertical moire pattern).
Caution:
if the moire reduction is overcorrected, the picture quality (for example focus,
vertical line stability, etc.) will sometimes be affected.
Keep this adjustment within the range in which the picture quality is not affected.
AAR H. Moire : + The moire correction circuit can be switched On and Off with the Z] key,
* When the moire correction circuit is switched On with the [2] (On / Off) key,
the adjustment screen menu appears.
* Adjust with the [4 and BP keys so that the striped moire pattern is in its
optimum condition.
ee
o
-
——
es
+e
V. Moire
: + The moire correction circuit can be switched On and Off with the Z key.
* When the moire correction circuit is switched On with the [2] (On / Off) key,
the adjustment screen menu appears.
* Adjust with the [4 and P) keys so that the striped moire pattern is in its
optimum condition.
PE
Language
. The language of the On-Screen Display can be selected from among
German, French, English, Italian and Spanish.
Select with the di or BP] keys.
000
"t
95
OSD
Position
: ttis possible to adjust the position and color that the on-screen panel
is to be displayed.
The panel will rotate in a counter-clockwise direction every time the
[2] key is pressed.
The screen color layout can be changed by holding down the [2] key
and pressing the [4 key. Six different color layouts are available.
Fi
Degauss : Use this function to reduce the irregular colors in the image.The degaussing
operates for approximately five seconds after pressing the [2] key .
Use this function when irregular colors occur in the image after moving the
monitor or the changing the screen angle.
Note: Be informed that a frequent use of this function is not recommended.
(Try to keep an interval of about 30 minutes or so between
operations.)
24
Signal . This displays the input synchronization signal frequency.
Information on the input screen mode (resolution, horizontal and vertical
synchronization frequency) will be displayed on the display monitor.
There are occasions sometimes when some screen modes in use do not display
any resolution.
To directly select the Signal Menu press the [2] Key. This permits you select the
active input connector Á (15 Pin Mini D-Sub) or B (5 BNC).
-13-
Publicidad
