Work - Fimap UP36 Manual De Uso Y Mantenimiento

11
9
13. Push the vacuum pipe inside the guide on the appliance body
(Fig.13).
14. Wind the vacuum hose around the lower (17) (Fig.14) and upper
(18) support (Fig.15).
13
To start working, proceed as follows:
1. Make sure the bag filter (1) is suitable for use and properly
inserted (Fig.1) (read the chapter "MAINTENANCE").
2. Make sure the vacuum motor intake air filter (2) is suitable
for use and properly inserted (Fig.2) (read the chapter
"MAINTENANCE").
1
5. Plug the power supply cable into the mains socket.
6. Switch on the machine by positioning the main switch (5) to "I"
(Fig. 5).
ATTENTION: the vacuum motor will now start to work.
7. Press the handle release pedal (6) and recline the control handle
towards you (Fig.6).
ATTENTION: as soon as the handle is in the working position,
the green light (7) on the brush head unit comes on (Fig.7).
The brush motor will now start to work.
ON
5
5
12
11
10
17
14

WORK

1
2
2
6
6
27
14
11
15. Wind the power cable around the lower (19) (Fig.14) and upper
(20) support (Fig.15).
16. Fasten the power cable by means of the tie attached to the cable.
18
19
15
3. Make sure the vacuum motor outlet air filter (3) is suitable
for use and properly inserted (Fig.3) (read the chapter
"MAINTENANCE").
4. Make sure the brush (4) is suitable for use and properly inserted
(Fig. 4) (read the chapter "MAINTENANCE").
3
8. Proceed with the work.
ATTENTION: if the control handle is positioned vertically
during the work the brush motor will stop while the Vacuum
motor will continue to work.
ATTENTION: if the vacuum pipe (8) is removed during work
(Fig.8), the brush motor will stop while the vacuum motor
continues to work.
7
15
13
12
20
3
4
7
8
16
4
8