Safety instructions
Meaning of specific safety instructions
For certain situations the applicable safety instructions are given at the relevant place
in the operating instructions. These instructions must be observed in order to prevent
physical injury, damage or harm to the environment.
Statutory requirements
In addition to the safety instructions in this operating manual, the statutory accident
prevention and environmental protection regulations applicable in the country of use
must be observed. Likewise the generally accepted rules for safety and working in a
technically correct manner must be observed.
Consequences of failure to observe the safety instructions
Failure to observe the safety instructions can lead to accidents with resultant physical
injury, damage or harm to the environment.
The manufacturer accepts no liability for injury or damage resulting from failure to
observe the safety instructions.
Intended use
The induction welding tool has been designed exclusively for the installation of roofing
membranes recommended by SFS on roofs.
Only fasteners, stress plates and sleeves approved for the tool and provided by
SFS may be used. The tool must be used within the limits defined in the
"Technical data" section.
Foreseeable misuse
• Starting to use the tool without instruction.
• Rendering the safety features inoperative and removing the warning labels.
• Working on roofs with a slope of more than 10°.
• Working backwards on roofs.
• Unsafeguarded or reckless working on roofs.
• Modifying the tool without the permission of the manufacturer.
• Using accessories or spare parts from another manufacturer without the permission
of SFS.
DANGER!
•
In the case of misuse there is a risk of death or injury, damage to the tool and
damage to the material processed.
•
It is not permitted to open the
stances. Non-observance involves the risk of death or injury, damage to the tool
and damage to the processed material.
induction welding tool under any circum-
isoweld
®
33