Publicidad
Idiomas disponibles
Idiomas disponibles
Additional setting options
By pressing the
Menu
the unit of measure (mm/mil).
OK
1. Press the
2. Press the
L
3. Confirm the selection by pressing the
4. Press the
M
5. If you want to change these too, repeat steps 1 to 3 accordingly.
6. Press the Menu button in order to return to the standard view.
The parameters have now been set and stored.
The tool is now ready for operation. (status display
Test welding
SFS recommends that a test weld be carried out after
calibration and before starting installation. Position a
stress plate on a level, heat-resistant base and place a
piece of the waterproof membrane to be used on it. Carry
out a test weld (see section on welding operation). Allow
the weld to cool down for at least 10 minutes. Try to
disengage the plate from the waterproof membrane with
the help of pliers. If the membrane offers a lot of resist-
ance or is destroyed in the process (after tearing off the stress plate), the weld has
been successful. Should the welded waterproof membrane not have sufficient
adhesion to the stress plate, you need to check the settings (parameters) at the
tool etc. For technical assistance, please contact your service provider. You will find
this at www.sfs.biz.
button you can set the volume and tone of the signal sound and
To set one of these parameters, proceed as follows:
For example, the position display is on selection of
volume (*first line).
button. ≥ appears and flashes.
or
button until the required volume is reached.
M
button to move to the selection of tone or unit of measure.
button. appears.
OK
lights up green).
M
47
Publicidad
