Dreame VTE1 Manual Del Usuario página 12

Installation
2-in-1 Charging & Storage Mount Installation Diagram
The 2-in-1 charging & storage mount is an optional accessory. You can install it based on
your needs.
1. The 2-in-1 charging & storage mount should be installed in a cool, dry place with an
electrical outlet nearby. Prior to installing, ensure that there are no electrical wires or
pipes in the space directly behind where the mount will be installed.
2. The bottom o the mounting template sticker should be level and at least 103cm rom
the ground, and its top should have at least 30cm* o clearance above it. (*30cm: Leave
enough space just in case you may need to purchase the replaceable battery in the
uture.)
3. Use a power drill with an 8 mm drill bit to drill a hole into each hole marker on the
mounting template sticker, then insert a wall plug into each hole.
4. Align the position holes on the mount with the holes on the wall. Fasten it to the wall with
the included screws.
8
30 cm
103 cm