Publicidad
Idiomas disponibles
Idiomas disponibles
2610055543.qxp_GKT18V-20GC 5/26/20 4:37 PM Page 27
Sawing with Rip Fence
The rip fence 35 (sold separately) enables
exact cuts along a workpiece edge and
cutting strips of the same dimension.
A.
Slide the guide rods of rip fence 35
through the guides in footplate 7 (Fig.
28).
B.
Thread the wing bolt assembly 35a into
front mounting 10. Thread the wing bolt
35b into rear mounting 17. Do not
tighten the wing bolts yet (Fig. 28).
C.
Adjust the desired cutting width as the
scale value at the respective line guides
33 or 34, see section "Cutting Line
Guides".
D.
Tighten the wing bolts
Sawing with Straight Edge
Guide
For sawing large workpieces or straight
edges, a board or strip can be secured with
clamp
C
as a straight edge guide. The footplate of
the circular saw can be guided alongside
the straight edge guide
•
The straight edge guide should be
positioned such that the motor side of
the saw rides against it when cutting the
desired line.
•
The deeper the cut, the thinner the
straight edge guide must be, because
the clearance below the battery pack
along the motor side of the base can be
limited.
•
Ensure that the clamps do not interfere
with free movement of the saw.
ind Quality Products Online at:
Operating Instructions
35a and 35b
(sold separately) to the workpiece
36
(Fig. 30).
GlobalTestSupply
www.
35b
17
.
35
35
27
.com
Fig. 28
35a
10
7
Fig. 29
Fig. 30
36
C
sales@GlobalTestSupply.com
Publicidad
