How To Turn The Camera On/Off And How To Record - Num'axes EYENIMAL Petcam Manual De Instrucciones

To charge the battery, remove the protection tab under your camera, (See diagrams §
Description). Connect the video camera (turned off) to your PC using the cable
provided.
For the following charges, charge for 5 hours for a full battery. The computer must be
turned on or on standby to charge.

ID sticker
Should your pet or the camera be lost, there is an area at the back of the camera
where pet owners can handwrite their names and contact details on the provided
sticker (See diagrams § Description).

Warning
Pet owners are advised to observe the usual precautions associated with the use of a
collar. It is recommended that pets, and especially cats be fitted with a safety or
breakaway-type collar to prevent collar injury or strangulation: safety collars either
made entirely of stretchy elastic material or, using the nylon-type, consist of two parts
connected by an expandable elasticated portion.
 Metal and other rigid-type collars should never be used.
 Remember to check your pet's collar regularly to ensure it fits; it will need
adjusting as your pet grows.

How to attach the camera to your pet's collar and fitting the collar
The fastening clip has been specially designed so the camera can fit on collars from
3/8 to 1.2 inch (from 1 to 3cm wide). To attach the camera to your pet collar, slide
the collar through the tab of the fastening clip and make sure that the camera is
securely in place.
The collar should always be fitted so it is comfortable but not too loose. The rule of
thumb is that there should be enough room to fit two fingers between your pet's neck
and the collar.
After having fitted the collar around your pet's neck, adjust the angle of the camera to
ensure that the lens is perpendicular to the ground.


How to turn the camera on/off and How to record

Before the first use, remove the plastic protection of the camera lens.
To turn on the camera, press and hold the button located on the side of the unit for 5
seconds (See diagrams § Description). When the blue light indicator is on and stays
lit: the camera is turned on.
To start recording, press the same button again briefly. The blue light indicator will
start blinking when the camera is recording.
To stop the recording press the same button again briefly. To turn off the camera,
press and hold the button for 5 seconds.
In case of camera malfunction, press the « Reset » button 5 seconds (See diagrams §
Description). The « Reset » button allows you to restore all factory settings.
CAUTION: if you do not use the camera for an extended period, you may need to
reset it in order to restart.
12