How To Use The Remote Control - Num'axes EXPERT 600 Manual De Instrucciones

CODING PROCEDURE FOR THE 1ST USE
1. Activate the remote control: firmly press for 1 second the On/Off button
the remote control.
2. Activate the receiver collar: move the remote control towards the collar so that the magnet position
indicator comes into contact with the red mark on the collar, hold for 1 second (ref. Diagram 5).
3. Move the remote control away from the receiver collar.
4. Press the V (vibration) button of the remote control. The collar emits vibrations; it is then synchronized
with your remote control.
RE-CODING PROCEDURE (for all codings other than the 1st)
1. Activate the remote control: firmly press for 1 second the On/Off button
the remote control.
2. Receiver collar in position "deactivated" (green indicator light Off): move the remote control towards
the collar so that the magnet position indicator comes into contact with the red mark on the collar,
hold for 6 seconds. The indicator light on the collar lights in fixed green then goes out.
3. Move the remote control away from the receiver collar.
4. Press the V (vibration) button of the remote control. The collar emits vibrations; it is then synchronized
with your remote control.
 Reprogram a receiver collar
The receiver collar can be re-coded indefinitely, either with the same remote control, or with a new
one from the EXPERT range (ref. Re-coding procedure).
WARNING:
The EXPERT receiver collar will not work with a remote control from the CANICOM range.
The CANICOM receiver collar will not work with a remote control from the EXPERT range.

How to use the remote control


The EXPERT 600 remote control is designed to operate with 1 receiver collar.
V button: vibration button
If you press the V button the receiver collar will emit vibrations. There is no time limit for this function:
the collar will continue to vibrate for as long as the button is pressed.
A « transmission » symbol will appear on the LCD screen of the remote control; the indicator light on the
collar goes from flashing green to permanent green for as long as the button is pressed.
It's up to you to use the vibrations depending on the way you want to train your dog. With the vibrations
you can:
- send a warning to your dog when it is disobedient,
- draw its attention,...
It's very important to always use the vibrations in the same way in order not to disturb your dog.
Gb - 24
located on the side of
located on the side of