How To Use The Remote Control - Num'axes CANICOM 1000 Manual De Instrucciones

3. Receiver collar in position « deactivated » (indicator off): approach the area where the On/Off
switch magnet is located in the remote control until coming in contact on white indicator located on
the receiver collar, hold for 6 seconds. The indicator lights in fixed green, then flashes in red.
4. Move the remote control away from the receiver collar.
5. Press the button
with your remote control.
If you have a second collar, renew the same procedure.
◆ Reprogram a receiver collar
Receiver can be re-coded indefinitely, either with the same remote control, or with a new CANICOM
remote control. (Ref. § Coding procedure).

How to use the remote control

The CANICOM 1000 remote control is designed to operate with 1 or 2 receiver collars. Before sending
any training instruction (beep sound or stimulations), you have to select the dog you want to send a
message to. Press the 1 or 2 key in order to select the collar (the number 1 or 2 will appear on the LCD
screen).
button: beeper
❖
If you press the « Beeper » button
for this function: the beeper will continue for as long as the button is pressed.
It's up to you to use the beeper depending on the way you want to train your dog. With the beeper button
you can:
- send a sound to your dog when it is disobedient,
- draw its attention,...
It's very important to always use the beeper button in the same way in order not to disturb
your dog.
❖ F button: Flash stimulation
Press the «F» button to send a warning to your dog using stimulations transmitted by the two contact
points located on the receiver collar for a defined length of time of less than one second.
❖ C button: Continuous stimulation
Press the «C» button to send a warning to your dog using stimulations transmitted by the two contact
points located on the receiver collar, this will last for as long as the button is pressed but limited to
8 seconds maximum.
If you press the «C» button for more than 8 seconds, the collar will automatically go into safety mode for
a few seconds before restarting itself normally.
All manuals and user guides at all-guides.com
of the remote control. A beep sound is emitted, the collar is then synchronized
the receiver collar will emit sound signals. There is no time limit
Gb - 20