Coding Of The Remote Control With The Receiver Collar; How To Use The Remote Control - Num'axes CANICOM VOICE 200 Guía De Uso

•

Coding of the remote control with the receiver collar

The coding of the remote control with the receiver collar enables the two units to work together.
IMPORTANT: before beginning the coding procedure, make sure no other person is using his Canicom Voice or
other products from the NUM'AXES range close by. Your receiver collar could accidentally record the code of his
remote control. If that occurs, re-code the remote control with the receiver collar.
CODING PROCEDURE
1 - Receiver collar in position "deactivated" (indicator light off): move the remote control towards the collar
so that the symbol of the remote control comes into contact with the
collar, hold for 6 seconds. The indicator on the collar lights in fixed green then flashes in red.
2 - Move the remote control away from the receiver collar.
3 - Press the "beep sound" button of the remote control. The collar emits a beep sound; it is then synchronized
with your remote control.
If you have two collars, renew the same procedure.
•
Reprogram a receiver collar
The receiver collar can be re-coded indefinitely, either with the same remote control, or with a new Canicom Voice
remote control (ref. Coding procedure).
•

How to use the remote control

The Canicom Voice remote control is designed to operate with 1 collar.
•
button: beep sound
If you press the button, the receiver collar will emit beep sounds. The collar will continue to beep for as long
as the button is pressed. It is possible to use the beep sound in several ways depending on the training method
you use. It can:
With the beep sound you can:
−
send a warning to your dog when he is disobedient,
−
draw his attention from distance,
−
serve as a reminder to call him back...
It's very important to always use the beep sounds in the same way in order not to disturb your dog.
•
button: vibrations
If you press the button, the receiver collar will emit vibrations. The collar will continue to vibrate for as long as
the button is pressed.
Vibration can be used in several ways depending on the dressage method you use.
With the vibrations you can:
−
send a warning to your dog when he is disobedient,
−
draw his attention from distance,
−
can be used as a reward when the dog obeys...
It's very important to always use the vibrations in the same way in order not to disturb your dog.
Guide d'utilisation CANICOM Voice – indice B
symbol located on the receiver
17/56