Publicidad
Idiomas disponibles
Idiomas disponibles
Glass door overlay panel - Preparation:
Create the custom overlay panel using the dimensions shown
in the illustration "Glass door overlay panel and hinge routing
dimensions". Rout shaded areas to a 1/2" (12 mm) depth as
shown.
IMPORTANT: The following graphic shows a custom panel
for a door with the hinges installed on the right-hand side.
If your refrigerator has the hinges installed on the left-hand
side, rotate the custom frame 180° so the hinge markings
will be on the left.
1/4"
(7 mm)
4
15
1/8"
(3 mm)
(125 mm)
1/2"
(12 mm)
Glass door overlay panel and hinge routing dimensions
Handle (optional)
Custom handles are typically attached to the custom overlay
door panel only.
Refer instructions received with KitchenAid handle kits to
install these handles on custom wood panels.
Custom handle needs to be installed on the door panel with
countersunk holes and installed before the custom overlay
door panel has been installed on the refrigerator door.
Manual W11515231B -SD-Ingles.indd 5
Manual W11515231B -SD-Ingles.indd 5
2"
/
"
16
(53 mm)
23
3
/
"
4
(60.3 cm)
17
1
/
"
16
30
5
/
8
(43.3 cm)
(77.75 cm)
21
/
"
13
16
(55.4 cm)
Electrical Requirements
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your refrigerator into its fi nal location, it
is important to make sure you have the proper electrical
connection.
Recommended grounding method:
A 115 V, 60 Hz, AC only, 15 A or 20 A fused, grounded
electrical supply is required. It is recommended that a
separate circuit serving only your refrigerator be provided.
Use an outlet that cannot be turned off by a switch.
Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning,
"
or removing a light bulb, unplug refrigerator or disconnect
power.
INSTALLATION
INSTRUCTIONS
Unpack the Refrigerator
Use two or more people to move and install or
uninstall appliance.
Failure to do so can result in back or other injury.
Before using your refrigerator, all packaging materials should
be removed and the interior should be cleaned.
Remove tape and glue residue from surfaces before turning
on the refrigerator. With your fi ngers, rub a small amount of
liquid dish soap over any adhesive and wipe with warm water
to remove.
Do not use sharp instruments, rubbing alcohol, fl ammable
fl uids, or abrasive cleaners to remove tape or glue.
These can damage the surfaces of your refrigerator.
For more information, refer "Refrigerator Safety" section.
Electrical Shock Hazard
Excessive Weight Hazard
5
02/02/21 15:14
02/02/21 15:14
Publicidad
