Pioneer DEH-790 Manual Del Propietário página 10

Pausing
1.Press button [9] to pause during disc
playback (Track number [38] will change
to "----", and "PAUSE" [42] frame ap-
pears).
2.Press button [9] again to release pause.
* It is possible to select music even during
pause by using the track number search
_ ("---" [38] will change to Track number,
and "PAUSE" [42] frame turns off while
the music is being selected).
When the selection is completed, the
playback will be paused at the beginning
of the music.
Using Highlight Scan
Highlight Scan is designed to enable you to
conveniently scan all pieces of music con-
tained in the disc by playing 10 seconds
each at your designated point of time after
the start of the music. The starting time of
play is set at one minute in factory.
Therefore, the Highlight Scan begins one
minute after the start unless you designate
it otherwise.
When you do not want to change the facto-
ry-set time:
1.Pressing Button [11] turns on the frame of
Highlight Scan [44].
2.The contained pieces of music will be
played in sequence for 10 seconds each
one minute after the beginning.
3.Press Button [11] again when your select-
ed piece comes, and it will continue to
play. At this point, the Highlight Scan dis-
continues to operate.
* The previous function automatically re-
sumes when a piece of music with which
Highlight Scan began returns.
10
Changing the Starting Time of Highlight
Scan
When you want to set the starting time of
the Highlight Scan to 30 seconds:
1.Indicate "MANU" [41] on the display by
simultaneously pressing the (+) side and
the (-) side of button [4].
2.Keep pressing either (+) or (-) side of
Button [4] until the numerals reaches 30.
3.Pressing Button [11] for 2 or more sec-
onds, turns on the frame of Highlight
Scan [44].
Highlight Scan will begin 30 seconds after
the start of the next piece of music.
¢ The starting time of Highlight Scan can
be designated at ten or tens of seconds
only. A tenth or tenths of seconds can be
disregarded.
If a piece of music ends before your des-
ignated point of time at which Highlight
Scan starts, the scanning is performed for
its beginning 10 seconds.
If a piece of music lasts Jess than 10 sec-
onds, so does the Highlight Scan.
You may wish to change the starting time
ionger without suspending the function.
You may do so, however, only to a rela-
tively long-playing piece of music be-
cause, as a matter of course, the time
cannot be set so as to come after the end
of the music.
Using Music Repeat and Random
Play
Each Press of button [10] causes the mode
to change as follows: Music Repeat, ("RPT"
[39] and "MODE" [43] frames appear.) —
Random Play ("RDM" [40] and "MODE"
[43] frames appear) —~ Normal ("MODE"
[43] frame turns off).
Music Repeat
1.To repeat the music you are listening to,
select the repeat mode ("RPT" [39] ap-
pears).
2.To cancel music repeat, press button [10]
to turn off "RPT" [39].
* When music repeat is not operational, the
whole disc will be played repeatedly.
Random Play
1.To play music randomly, select the ran-
dom play mode ("RDM" [40] appears).
Once the current track has been played,
the microprocessor will randomly select
the next and subsequent tracks.
2.To cancel random play, press button [10]
to turn off "RDM" [40].
* Since selections are played in random or-
der, the same selection may be played
twice in succession.