Pioneer DEH-790 Manual Del Propietário página 8

BSM (Best Stations Memory)
This function automatically locates stronger
stations and automatically assigns their fre-
quencies to the buttons in Bank [12]~[17],
from strongest to weakest. It comes in
handy when trying to find local stations
while driving.
1.Press button [3] and select a band.
2.Hold down button [11]. After about 2 sec-
onds, a" beep" will sound to signal that
the BSM search has started. At this time,
"BSM" will flash on the display.
3.The frequency display will return once
BSM search is complete, and frequencies
are assigned to buttons 1 through 6 in
Bank (12]~[17].
« At the end of the BSM search, the dis-
played frequency is that assigned to but-
ton CD) of Bank [12]~[17].
+ You can cance! BSM search by pressing
button [11] again.
If there are fewer than 6 strong stations in
the area, some of the buttons in Bank
[12]~[17] will not be assigned frequen-
cies, so they will retain any frequencies
assigned to them previously.
BSM search may take_as long as 30 sec-
onds in areas where there are few strong
stations.
Preset Scan Tuning
This function lets you automatically monitor
the stations assigned to the preset buttons.
1.Pressing button [11] turns on the frame of
preset scan [36] and flashes preset num-
ber [30]. .
Each station assigned to the buttons in
Bank [12]~[17] will be automatically tuned
in for about 8 seconds.
2.When you hear a station that you like,
press button [11] again to cancel preset
scan tuning and remain at that station.
Playing Compact Discs
Parts Identification
Fig. 1
[4] Track number search/
Fast forward, Reverse
[5] Disc insertion slot
[6] Display
[7] Eject
[8] Source selector
[9] Pause
[10] Mode
{11] Highlight scan
Fig. 4
[38] Track number
[39] Music repeat
[40] Random play
[41] Manual
[42] Pause
[43] Mode
[44] Highlight scan
Discs
* Only use compact discs (optical digital
audio discs) bearing the mark shown be-
low. (Fig. 13)
) Site
DIGITAL AUDIO Fig. 13
* Be sure never to touch the signal surface
when handling discs. Pick up discs by
grasping the outer edges or the edge of the
hole and the outer edge. (Fig. 14) (Fig. 15)
a
Fig. 15
* Do not affix paper or tape, and avoid
scratching the side of the disc which con-
tains the label (contents of disc).
¢ The disc revolves at high speed within
the player unit, so defective (cracked or
badly bent) discs should not be used.
* Dust and/or finger smudges will have no
direct effect on the signal recorded on the
disc, but dirt can decrease the amount of
light reflected from the recorded surface,
thus affecting sound quality. If the disc
should become soiled, gently wipe the
surface with a soft lint-free cloth, wiping
from the center of the disc to the edge.
(Fig. 16)
; ; Fig. 16