Fitting The Headrest - Invacare Aquatec Ocean E-VIP Manual De Instrucciones

Assembly and installation
5. Attach a safety clip C on the inside.
6. Insert cable B of drive D as far as possible into chassis A.
7. Use cable tie C provided to secure the cable of the drive in this
position.
!
IMPORTANT
The armrests face forward when folded down.
8. Insert both sides of seat frame F into receivers H on chassis J.
9. Insert the two 35 mm bolts G into receivers H from the outside,
push in fully and attach safety clips I on the inside.
10. Tilt the seat frame until the holes in bracket E on the seat frame
and in fork A on seat tilt drive D are aligned.
Shower and Toilet Commode Ocean E-VIP
11. Insert the 23 mm bolt B into the holes from the outside and attach
safety clip C on the inside.

4.3 Fitting the headrest

!
IMPORTANT
Retaining bar C can be fitted with the curve to the front or
back, depending on the user's requirements.
The headrest cushion J can be removed and replaced with
other cushion shapes (optional).
▸ To remove the cushion, undo mounting screws I.
1. Twist the screw with hand knob F a little way into brace G.
2. Attach the brace with the screw to the handle of backrest E from
the back in such a way that the screw enters the hole in the handle
of the backrest.
3. Insert plate D into the brace from the front in such a way that the
two lips of the plate face upwards and downwards and the curved
side of the plate meets the handle of the backrest.
!
IMPORTANT
When inserting the support, the curve of the plate must be
fully flush with the backrest handle.
4. Insert retaining bar C into the recesses of the brace from above.
5. Tighten the screw with hand knob F until the retaining bar is
secure.
6. Insert cushion J together with cushion support B into bracket H
on the retaining bar.
7. Tighten the upper screw with hand knob A until the cushion sup-
port is secure.
7